Monday , May 21 2018
Home / business / Winter fishing on the river

Winter fishing on the river

Fishing from the ice in large rivers with a noticeable and even strong current is associated with considerable difficulties due to the features of the device gear and special equipment for their application. Among other things, on the winter river is not enough to know the place where can stay one or the other fish, they each year have to find it again, since once the spring flood varies the bottom shape seems to be well-known sites beyond recognition.

So the main thing that is required from the angler on the river is to be able to thoroughly examine a chosen area and to find any feature at the bottom, where Parking is available in fish. In this case help and simple measurements of depth, portable fish finder, and observe other anglers. However, the latter can play a cruel joke on those who wish to join the crowd, where it seems there is a good bite. In fact, usually in the heap well catch only one or two, and the rest are present as extras. Therefore it is better to look for their catchability “point”, your fish, and good luck resistant and does not shy away…

For this business will need a good drill with sharp knives. It is necessary to have any spare knives or diamond needle files for editing hooked knife on the over in the ice a lot of inclusions of fine river sand. Also need a ladle with a long handle and bagaric having a working length of not less than a meter. The fact that even on a strong current because of the rapid mixing and cooling of water ice reaches a thickness greater than the reservoirs.

Useful and thin stick with a flyer on the end, the length of which must also exceed the thickness of the ice. It can be cut in the coastal willows. Such a tool is necessary for the reason that a strong vortex over the fishing line is pressed against the wall of the pit and continuously moving up and down due to changes of water pressure on it: the scaffold is gradually “propisivat” ice and the cracks when removing the gear stuck it sinker, jig. And if the fish hook, such obstacle usually leads to her on the spot. With the help of flyer gear is pushed from the cut and safely removed from the hole. To further get rid of the mentioned inconvenience, the hole should be drilled in the ice with a significant tilt: sabrepulse screws, first vertically and then leans to one side as the diameter of the screw, the inclination of the holes in the ice goes in the direction of flow.

For strong currents and considerable depth, the tackle should be heavy. Tend to use snap-in end-sinker and leash above him. The simplicity of the tackle is very conditional. The main thing — in the configuration snap-in under the specific conditions of fishing: the depth and strength of currents, the activity of the fish, the other anglers. The last significant because too light tackle will be exposed to a large demolition over and will be the “catch” below seated anglers. On the contrary, too heavy tackle, standing in the hole vertically, will catch close located upstream of the brethren on the passion, and the fish it is likely to ignore.

See also:  Yushchenko said the collapse of Ukrainian banking system

Ideally, the fishing line with a sinker under the action of the flow went in the hole at an angle of about 30 degrees, that is almost under the angle of the barrel hole to the stream. So the tackle becomes very sensitive to biting, since most of the force when patike fish will fall on the line that runs to the hut and not on the sinker.

Another important rule: the stronger the current, the heavier the load and longer and thinner leash; the shallower or weaker the current, the easier the load will need. Usually anglers carry a set of interchangeable sinkers of different weights and leashes of various lengths and diameter, fitted with a jig, a hook, and it is stored at marked motoviltsa. Sinker and leash are attached with carabiner and swivel — this prevents twisting of the fishing line and allows you to quickly change gear.

At stationary fishing for when the fish are found, the main line is rather large diameter, 0.2-0.25 mm, which slows down the process of “propilivanija” wall of the hole and prevents the rig from tangling on the ice when fishing in strong wind. On leashes is a quality transparent monofilament with a thickness up to 0,15 mm.

The most important item of tackle — pointer with variable length of the elastic element. His working part should only counteract the pressure of the flow on the line, as a sinker with this method of fishing is at the bottom. Ideally, the correct pointer is bent under the influence of the flow at an angle of 30-45 degrees to the surface of the ice.

Spinning is needed equipped with built-in or movable coil of sufficiently large diameter to maneuver with the gear. It needs to have a heavy handle, and the dirty pole — flyer-stand: so its not a “delay” in the hole, or do not fold back with a sharp bite.

Fishing starts from lowering tackle under the ice. To the leash didn’t obratilsa around the main fishing line or hook is not caught on other elements of the snap, with one hand hold the hook or jig with bait, and the other hand to lower the hole of the sinker, moving simultaneously on a tight line the lure to the surface of the water, and then let go and it in the hole. Then is discharged into the water main line until the sinker of the bottom that will be seen by the short-term weakening of the deflection of the gatehouse. In any case it is impossible to prevent free fall snap on the bottom! When the sinker lies on the bottom, it is necessary to pass on for additional 0.5-1 m main fishing line and spinning to install over the hole.

See also:  Ukraine has a winter of more than 15 billion cubic meters of gas

If for some time no bites, you should tackle smoothly raise 1-1,5 m and again slowly lower to the bottom. Sinker is somewhat shifted downstream, but the stock free of the fishing line already been done. Often bites occur it is this manipulation or immediately after it — the fish grabs “on the line”. This work with the gear should be carried out continuously, alternating with pauses, the duration of which is determined by the activity of the fish. When good Kleve need in these “game” usually does not happen.

Bite on a strong current are expressed in fractional and sharp fluctuations of the signal tip of the gatehouse — cutting should follow immediately and go to the fish if the fish on the hook. If the fish is not caught, the tackle is removed and baited with fresh bait — for fish it usually breaks.

Lately as the widespread decline of fish population due to poaching and excessive appetites themselves anglers fishing technique on the strong river flow was much improved, she got kind of flop bottom posting method is also called “roll a ball”. This fishing only won, she became more active, running than enough passive sitting over the hole with a stationary heavy bottom snap.

The most popular bait for fishing in winter time is big for bloodworms. The hook usually sits 1-3 larvae. At the beginning of freeze-up on the river, until the fish has lost a sufficiently high activity, it is well to bite when the hook baited with two or three larvae of a large moth. But then the bites become ultra-cautious. Therefore it is better to catch a single larva, but still often change it on the hook if the bite stops. In this case, when a bad biting bloodworms it is better to pierce the tip of the hook through not near the head, and in the middle of the body — so is more successful bites.

© 2017, All rights reserved.

Check Also

Deputies of the state Duma was caught in the fact that they weekly are tightening the rules for business

Deputies of the state Duma in 2017, at least once a week tightened legislation in …

Leave a Reply

Your email address will not be published. Required fields are marked *